io per NC avevo trovato la seguente procedura da fare a seguito di disconnessione della batteria (una specie di ricalibratura)
non so su ND...
WARNING:
• Unless the initialization procedure of the steering angle sensor is completed, the DSC
will not operate, causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC operation if the power supply to the steering
angle sensor has been cut off due to disconnection of the steering angle sensor connector or negative battery cable, or any other cause.
a. Ensure ignition switch is in the ON position.
b. Confirm that the DSC indicator light illuminates and that the DSC OFF light flashes.
c. Turn the steering wheel to full right lock, then turn it to full left lock.
d. Confirm that the DSC OFF light goes out. (DSC indicator light illuminates)
e. Turn the ignition switch off.
f. Turn the ignition switch to the ON position again, and confirm that the DSC indicator light goes out.
NOTE:
• If the DSC indicator light does not go out, turn ignition off, disconnect and connect the negative
battery cable, and then perform the procedure again starting from SUB-STEP “a”.
non so su ND...
WARNING:
• Unless the initialization procedure of the steering angle sensor is completed, the DSC
will not operate, causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC operation if the power supply to the steering
angle sensor has been cut off due to disconnection of the steering angle sensor connector or negative battery cable, or any other cause.
a. Ensure ignition switch is in the ON position.
b. Confirm that the DSC indicator light illuminates and that the DSC OFF light flashes.
c. Turn the steering wheel to full right lock, then turn it to full left lock.
d. Confirm that the DSC OFF light goes out. (DSC indicator light illuminates)
e. Turn the ignition switch off.
f. Turn the ignition switch to the ON position again, and confirm that the DSC indicator light goes out.
NOTE:
• If the DSC indicator light does not go out, turn ignition off, disconnect and connect the negative
battery cable, and then perform the procedure again starting from SUB-STEP “a”.
